A cable that "works" when you plug in a laptop isn't the same as a cable that's certified. Certification runs a Fluke-class analyzer against the full TIA pass/fail spec for the category installed, and hands you a report — not a guess.
This is the verification step behind every job we run, residential or commercial: nothing gets called "done" until it's tested and documented.
Every run is measured against the category's rated limits — not just "does it link."
Certification is included in every drop and fiber termination we install — priced in, not a hidden add-on.
Wire map, length, insertion loss, NEXT & return loss on every Cat6/Cat6A run.
OTDR / insertion-loss results on every fusion or mechanical splice.
Re-certify or diagnose existing cabling we didn't originally install.
A few questions specific to this step.
A link light doesn't tell you if a run will actually hold 10 Gbps, or if it's marginal and will start dropping packets under load. Certification measures the run against the category's real electrical limits — link lights don't.
Permanent link testing checks the fixed cabling itself — from the patch panel to the wall jack — which is what we install and certify. Channel testing adds your patch cords on both ends and reflects the exact connection your equipment will use.
Yes — a documented pass/fail report per run is available on request, along with a labelled room or rack map so you know exactly what each result corresponds to.
Yes — we can certify or diagnose existing runs, which is useful before closing on a property or troubleshooting a network that's underperforming.
Send your blueprint, drop count, or a few photos. We'll confirm a site visit and a clear quote in CAD — we supply the cabling, you supply the devices, we install.