We terminate Cat6A, coax, and fiber to the connector each media requires — keystone jacks, punch-down patch panels, fusion pigtails — then label every cable and port to a consistent TIA-606 identifier scheme so it stays traceable for the life of the building.
A wall plate label that matches its patch-panel label sounds small, until you're the one trying to find "which cable is this" three years from now.
Termination method changes by media; the labeling discipline never does.
All prices CAD, labour + OpticPulse-supplied materials. Build an exact estimate for your project on the pricing page.
Terminate an existing cable run with a flush, labelled wall jack.
Terminate both ends of an existing cable, labelled and tested.
Add and label a port matched to its wall-plate counterpart.
A few questions specific to this step.
They're two accepted wiring pinouts for terminating Cat5e/Cat6/Cat6A — functionally equivalent as long as both ends of a run match. We standardize on one across your whole project so every termination is consistent.
A short, machine-printed identifier — for example a room or rack code plus a panel and port number — applied at both the wall plate and the matching patch-panel port, so the two always read as a pair.
Yes — we can trace out an unlabelled or inconsistently labelled system, then re-terminate and re-label it to a clean, consistent scheme with a cable schedule to match.
Both — the physical labels on the cable and ports, plus a written cable schedule listing every ID, its source, its destination, and the cable type, available on request.
Send your blueprint, drop count, or a few photos. We'll confirm a site visit and a clear quote in CAD — we supply the cabling, you supply the devices, we install.